Dive Manager for motor/pump

recirculating air ballast system (RCABS)
click for larger image
  • Isolated (non-plating) water level detection
  • Selectable servo position on failsafe/surface
  • Proportional or ON/OFF compressor power
  • Power limitation to allow 6 volt motor to run on 12 volt
  • Low loss 0.003 ohm driver for continuous stall rating
  • Thermal overload protection
  • Switchable Battery Elimination Circuit
  • 0 to 26 VOLT RANGE (7-26 using the B.E.C.)
  • 1 x 2 x 1/2 inch dimension
  • operates glitch-free with a poor radio signal
    • FAILSAFE MODES
    Each force the valve servo to FAILSAFE/SURFACE and stop the pump

    1. 2.5 second of radio failure
    2. Receiver battery supply falling below 2.9 Volts.
    3. Pump battery supply falling below 8 Volts. (selectable ON or OFF)

    Each force the the pump to stop immediatly

    1. 90 degree Celcius thermal trip on the pump drive.
    1. Moisture between the a.c. probe/detector (yellow/green).


    STATUS INDICATORS
    1. Surface      (flashing) = SURFACE command from the receiver
    ON = programming the servo position on surface/failsafe
    2 Dive      (flashing) = DIVE command from the receiver
    ON       = 90o C thermal cutout on the pump driver
    3. Tank Full     PROBES DETECT A FULL BALLAST TANK
    4. Radio Fail     Radio failure or a poor radio signal
    connection diagram
    To store Valve Release position
      
    1. hold the button marked "SETUP"
    2. move the transmitter control until the servo hits the valve release
    3. release the SETUP button
    		 [centre lever and trim]
    To change the maximum duty cycle to the pump.
    If you have a  540 ,or other 6 volt motor based pump, you can use double the voltage by selecting setting 3 or 4 below.

    1. hold the setup button when applying the battery or switching on from the bec loop or switching on receiver power.(which ever is powering receiver)
    2. release on one of the four flashing lights

      1      ORANGE full pump power available (proportional to stick)
      2     YELLOW full pump power available (abrupt)
      3     GREEN 50% pump power available (proportional to stick)
      4     RED       50% pump power available (abrupt)