Model Submarine Electronics

PDF 104kb

spc-pro2 pitch control

click for summaryclick on image for more details

3 Position ballast servo control.

  • operates glitch-free with a poor radio signal
  • water level detection in ballast tank
  • time delayed radio failsafe
  • A.C. Isolated (non-plating) water level detection
  • adjustable servo positions for dive + surface
click for summaryclick on image for more details

dive manager

  • Isolated (non-plating) water level detection
  • Selectable servo position on failsafe/surface
  • Proportional or ON/OFF compressor power
  • Power limitation to allow 6 volt motor to run on 12 volt
  • Low loss 0.003 ohm driver for continuous stall rating
  • Thermal overload protection
  • Switchable Battery Elimination Circuit
  • 0 to 26 VOLT RANGE (7-26 using the B.E.C.)
  • 1 x 2 x 1/2 inch dimension
  • operates glitch-free with a poor radio signal
click for detailsclick on image for more details

AST pitch controller (discontinued)

  • Uses a precision integrated circuit sensor
  • ZERO long term drift
  • Maintenance free lifetime.
  • feedback light emitting diodes assist bench setup
  • Pushbutton setup- NO CARBON TRACK POTS
  • 3 Tilt sensitivities settings covering x1 x2 x4
  • touch compensates for both horizon and radio misalignment
  • Dimensions are 1.3 x 1 x 0.5 inches.
  • Maintains trim in astern motion.
  • Crash dive angle is 25o at all tilt sensitivities
click on image for more details

depth control (discontinued)

  • Dimensions are 1.3 x 1 x 0.5 inches.
  • microprocessor control
  • Uses a solid state pressure sensor
  • servo limited to 50o travel
  • One touch to NULL at the surface
  • reed switch wander permits NULL by magnet swipe outside the sub hull
  • compensates for transmitter stick misalignment