Solid State Speed Controller

microgyros
  • forward/reverse or forward or forward/brake mode
  • simple ONE TOUCH SETUP or
  • ADVANCED SETUP with varible throttle/brake/radio cutout
  • smooth high frequency operation
  • excellent microprocessor-based poor radio response
  • variable strength throttle
  • variable zero throttle position
  • variable strength brake
  • Switchable Battery Elimination Circuit
  • 0 to 26 volt range (7-26 with B.E.C.)
  • high power 2 x .003 ohm motor drive
  • overload protected
  • thermal cutout indicator visible with audible alarm
  • total radio failure visible and audible alarm
  • poor radio signal indication
  • throttle power indication
  • full throttle indication
  • brake strength indication
          forward brake reverse speed control 
hold while applying power
[power up with the button held]
To store ZERO THROTTLE
  
  1. position  throttle midway
  2. ensure radio failure is OFF
  3. press the SETUP button 

 Reply :  1 chirp with amber
 [centre lever and trim] [momentary press]
To set 100% THROTTLE  point
  1. deflect throttle to maximum
  2. ensure radio failure is OFF
  3. press the  SETUP button
repeat in reverse direction & after changing   zero or deadband
Reply :  3 chirps with amber
   [centre trim push stick to end] momentary press]
    
 
 


page 2   Advanced Setup  
 Throttle Response  - - - -  Dead band  - - -  Brake Response
To change the THROTTLE response
push stick in one direction until throttle light is on]
Push lever until amber indicates throttle is on.
repeat for the other direction
Hold until your option comes up
4.   Release on one of the 7 below:-
RED           reduce throttle response 
AMBER     increase throttle response
Reply :  long chirp with colour
BOTH       no power in this direction
RED       ( flashing)      max. throttle 20%
AMBER  ( flashing)     max throttle 40%
BOTH     ( flashing)       max throttle 60%
alternate (flashing)     max throttle 75%
Reply :  4 chirps with amber


To change the dead band
The dead band is the small percentage of throttle lever movement that results in no power to the motor
.

 [dead band]
centre trim and lever   store
4.   Release on one of the 7 sequences
RED       ( flashing)      4 degrees  
AMBER  ( flashing)      6
BOTH                        10 (default)
RED                           15
AMBER                     20
BOTH  ( flashing)        30
alternate (flashing)      50
Reply :  2 chirps with amber


To change the motor BRAKE  response time 
switch off press
 4.  Release on one of the 7 below.
 RED       ( flashing)     2.0 Second 
AMBER  ( flashing)    1.0 Second 
BOTH                        0.5 Second  (default)
RED                          0.3 Second 
AMBER                    0.25 Second 
BOTH   ( flashing)      0.16 Second
alternate (flashing)     0.1 Second
Reply :  5 chirps with amber